Cuisinart EM-600 Manuale di Manutenzione e Cura Scaricare il pdf (Pagina 8)

7

2. With a coffee cup or mug on the drip tray,

select COFFEE

(approximately 6 ounces).

(The coffee setting and if applicable the

temperature setting LEDs remain on, while all

the other LEDs are off. Once all LEDs are on

again, the machine is ready for the next

cycle.)

CAUTION: Scalding may occur if the brewing

head is opened during brewing cycle.

Reminder: There is no need to rinse in between

cycles as there will be no transfer of flavor. See

Espresso section NOTE on previous page.

Manual/Adjustable Strength Control

1. Using the lever, open the brew head, insert a

capsule, and close the brew head.

2.

For adjustable strength

control, use the MANUAL

button to adjust the length

of time espresso or coffee

is dispensing – the longer

you allow it to flow, the

lighter it will be.

Press to start dispensing. When your

cup is filled to desired level, press

again

to stop. Manual function will time-out after 90

seconds.

PROGRAMMING

A CUSTOM SETTING

At ready mode, press and hold MANUAL

for 3 seconds to customize the SHORT

,

LONG

and COFFEE output.

1.

, , are flashing and is ON. If no

action is taken within 30 seconds, unit

returns to preheat/ready mode.

2. Press

, or button.

a. Chosen setting and

LEDs remain on.

b. Espresso/coffee is dispensed.

c. When desired amount is dispensed into

cup, press chosen setting again to stop.

That will be the programmed amount and

unit will return to preheat/ready mode.

d. If no action is taken during dispensing

within 90 seconds, unit returns to preheat/

ready mode. Setting will not be changed.

To reset any setting to factory default (at ready

mode), press and hold

and chosen setting at

the same time for 3 seconds.

1.

or or and LEDs flash 3 times.

2. Default setting is on and unit will return to

preheat/ready mode.

STEAM/FROTHING MILK

1. Remove the milk tank by holding the milk

tank and cover, and pull away from the

machine. Remove the cover by pushing on

cover release button on back of milk tank.

2. Pour milk into the tank, above

minimum fill line (5 ounces),

but not exceeding the

maximum fill line (22 ounces).

3. Replace the cover, align the

milk tank to the connector

on the side of the machine,

and push in to install.

CAPPUCCINO

, LATTE

and STEAM will begin

to flash. This indicates that

the milk tank is properly

installed.

4. Place a mug on the drip tray and position the

steam/frothing wand in the mug. Adjust the

length of the stainless steel sleeve on the

wand so it is the proper length for your mug.

5. Once lights are steady lit press the STEAM

button to start steaming/frothing, and use

the steam control dial to control the air/froth.

Press

again to stop steaming/frothing.

Steam function will time-out after 30

seconds.

NOTES:

r 5VSOJOHUIFTUFBNDPOUSPMEJBM

to the right creates more

froth.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Commenti su questo manuale

Nessun commento